Overview

The Garmin 010-11676-00 is a quick release mount with tilt and swivel adjustment for the echo 200, echo 500c, and echo 550c.

It gives you a stable fixed-mount base on the dash, console, or a flat mounting surface, while still letting you angle the screen where it is easy to read when you are standing at the helm or seated. The quick release design also makes it practical to remove the display when trailering, storing the boat, or locking gear up after a day on the water.

A quick cable disconnect at the mount keeps wiring management cleaner, so you are not working behind the unit every time it comes on or off the bracket.

Key features

• Fits echo 200, echo 500c, and echo 550c mounting pattern and cradle interface
• Tilt and swivel adjustment to dial in viewing angle from the helm
• Quick release mount so the display can be seated and removed without fighting the bracket
• Quick cable disconnect at the mount to simplify connecting and disconnecting the unit
• Useful for boats that get trailered or stored, where removing electronics helps protect them from impact and theft

Installation and setup

Plan the mounting spot so the display can tilt and swivel freely without hitting windshields, rails, or throttle controls. Leave enough clearance to access the mount connections and route the cables with a gentle bend radius so they do not get stressed by vibration.

If you are replacing an existing bracket, compare the mounting hole layout and confirm the unit seats fully into the quick release cradle before final tightening. After the first few trips, recheck fasteners and cable support since console plastics and mounting surfaces can settle.

Compatibility and fit

This mount is intended for Garmin echo 200, echo 500c, and echo 550c units. Match your device model and existing cradle style before ordering, since similar-looking mounts can use different locking tabs or hole spacing across product families.

Use on board

It is a good match for small fishing boats, bay boats, pontoons, and center consoles where the display needs to be easy to angle for glare control and easy to remove for storage. It also works well when the same boat sees rough water and frequent trailering, where a secure bracket and clean cable handling matter day to day.

Maintenance and care

Rinse salt and grime off the mount after use, especially around the release points and swivel joints. Periodically inspect the locking interface and cable connection for grit buildup, and check that the mount stays tight to the surface after temperature swings and repeated vibration.