Overview

The Attwood Marine 11124-6 is a bearing boot cover for trailer hubs that use 1.98 inch bearing protectors. It fits over the exposed end of the protector to keep dirt and grime out of the hub area and helps stop grease from being thrown onto the trailer wheel while towing.

This is a straightforward trailer maintenance part for boat owners who tow regularly, launch in wet conditions, or store the trailer outside between trips. It does not replace the bearing protector itself. It works as the outer cover that keeps the hub area cleaner and better protected on the road.

Key features

• Fits 1.98 inch hub applications with bearing protectors
• Covers the exposed end of the bearing protector
• Helps keep road dirt and grime away from the hub area
• Helps reduce grease sling onto the trailer wheel
• Supplied as a pair for one axle set

Compatibility and fit

This cover is intended for trailer hubs that already have 1.98 inch bearing protectors in place. Checking the protector size before ordering is the main fit point, since the cover needs to seat over the outside of that protector correctly.

It is a good match for trailer owners who want a cleaner hub area without changing their current bearing protector setup. On saltwater trailers and on rigs that spend long hours on the highway, that extra barrier helps keep the outside of the hub and wheel area from getting messy between service intervals.

Installation and setup

Installation is simple. Clean any grease from the outside of the bearing protector, then press the cover into place so it sits evenly over the exposed end. A clean mounting surface helps the cover seat properly and stay in place during towing.

Because this part works over an existing bearing protector, it makes sense to inspect the hub at the same time for grease leakage, damaged protectors, or loose fit. That quick check can save time before the next launch or road trip.

What’s included

• One pair of bearing boot covers