Overview

The Blue Sea Systems 2716 is a busbar cover made for the Blue Sea Systems 2302 Common 150A BusBar with a 20-gang layout. It snaps onto the terminal studs and adds insulation over the connection area while keeping wire access open, which helps reduce accidental contact around exposed distribution points.

This is a fit-specific part rather than a universal cover, so the underlying busbar part number matters. It is a straightforward match when you are using the 2302 as a common point for positive distribution or for negative or AC ground collection on a boat.

Key features

• Made to fit Blue Sea Systems busbar PN 2302
• Matches the 20-gang Common 150A BusBar layout
• Snap-on attachment to the terminal studs
• Helps insulate exposed connections and reduce accidental contact
• Keeps access open for wire routing and service checks
• Polycarbonate cover construction

Compatibility and fit

This cover is intended for the Blue Sea Systems 2302 busbar, so it is best used when you need a clean, matched cover for that exact distribution block. On a boat with several branch circuits landing on one common bus, that fit matters because the cover needs to clear the stud locations and terminal layout without interfering with normal cable runs.

It suits owners, electricians, and refit installers who are building or tidying a distribution point under a helm, inside an electrical locker, or near a battery bank and want the terminals covered without changing the busbar itself.

Installation and use

The cover presses onto the busbar studs after the 2302 busbar has been installed and wired. Once in place, it leaves the wire entry area accessible, which is useful when the busbar remains part of a serviceable panel or distribution area that needs periodic inspection.

For retrofit work, this part also helps when an older 2302 installation is still in good condition but the exposed connection area needs better insulation and a neater finished look.