Garmin GT360UHD Transducer Mount, For Spy Pole

Overview

The Garmin 010-13404-40 is a GT360UHD mount for installing a GT360UHD transducer on a Garmin Spy Pole. It is used when the transducer needs a purpose-fit mounting point on the pole rather than a general bracket or improvised hardware.

This mount is a practical fit for anglers and boat owners setting up Garmin scanning sonar around a Spy Pole installation. Before ordering, match it to the GT360UHD transducer and the Spy Pole on board, especially when replacing a lost bracket or finishing a new sonar setup.

Key features

• Made for mounting a GT360UHD transducer to a Garmin Spy Pole.
• Helps keep the transducer installation tied to the intended pole setup instead of relying on universal hardware.
• Useful for new electronics installs, replacement mounting hardware, and sonar upgrades built around a Spy Pole.
• Supports cleaner rigging around the bow or fishing position by keeping the transducer mount matched to the pole system.

Installation and fit

Install this mount only with the transducer and pole combination it is meant to support. Confirm the GT360UHD transducer model and inspect the Spy Pole mounting area before installation so the bracket, cable path, and sonar orientation are handled cleanly.

As with any transducer mount, the final position matters. Keep the transducer clear of impact points, avoid sharp cable bends, and check that the assembly does not interfere with trolling motor movement, deck hardware, dock lines, or trailer loading.

Use on board

This mount is a good match for fishing boats using Garmin sonar from a dedicated Spy Pole position, especially where a controlled transducer location is important for scanning structure, bait, and fish around the boat.

After installation, rinse the area with fresh water after saltwater use and periodically check the fasteners and cable routing. Vibration, trailering, and repeated deployment can loosen hardware over time, so a quick inspection before a fishing day is worthwhile.