Overview

The Perko 096000099A is a spare bevel with cam for Perko's Fig. 0960 mortise latch set. It is the strike-side replacement used when the original bevel assembly is worn, damaged, or no longer holding the door cleanly. That lets you service the latch without changing the full hardware set.

This part is specific to the Fig. 0960 mortise latch system and uses the same reversible bevel arrangement used by that latch. It is a practical repair item for cabin, head, or other interior compartment doors where the rest of the latch hardware is still serviceable and the strike side is the part that needs attention.

Key features

• Replacement bevel with cam for the Perko Fig. 0960 mortise latch set
• Reversible bevel arrangement to suit the door swing during installation or service
• Lets you replace the strike-side latch component without replacing the complete latch set
• Uses #6 mounting screws; screws are not supplied

Compatibility and fit

This spare part should be matched specifically to Perko's Fig. 0960 mortise latch set before ordering. It is not a universal strike plate or a general latch part, so checking the figure number on the existing hardware is the safest way to confirm fit.

It suits repairs where the mortise latch body and trim are staying in place, but the bevel with cam has been bent, worn by repeated closing, or damaged during refit work.

Installation and setup

When replacing the part, confirm the bevel orientation against the way the door closes into the frame before fastening it in place. Because the bevel is reversible, the same replacement part can be set up to match the door swing used by the latch assembly.

This is a straightforward service item for anyone already working on Perko mortise door hardware on board. #6 mounting screws are used for the latch installation, and they are not included with this replacement part.