Attwood Marine Rod Holder Cap Gasket, For 30 Degree Rod Holders

Overview

The Attwood Marine 1478-1 is a black cap and gasket for a 30 degree rod holder. It is the top cover piece for this holder angle, so the main fit check is the 30 degree configuration rather than the boat model.

This part is useful when the original cap is missing, worn, or cracked and you want the rod holder opening covered again when it is not in use. On boats where holders stay exposed along the gunwale or cockpit edge, that small detail matters for day-to-day use and for keeping the installation looking finished.

The cap is built for the exposed conditions rod holders usually see, including sun and regular deck use. It suits fishing boats that keep flush-mount holders rigged full time and need the correct 30 degree cap rather than a 0 degree or 15 degree version.

Key features

• Fits 30 degree rod holder configurations
• Black cap and gasket assembly for the top of the holder
• UV-resistant construction for exposed deck and gunwale locations
• Closes the tube when the rod holder is not being used

Compatibility and fit

Before ordering, confirm the holder angle. This part is for 30 degree applications only and should not be treated as interchangeable with caps for other holder angles.

It makes sense for boats with flush-mount rod holders installed along the gunwale, where the holder opening stays exposed between trips. Anglers replacing one missing cap can match the angle first and then restore the holder with the correct top piece.

Installation and use

Installation is straightforward once the holder angle matches. This is a simple service part, but it is worth checking the existing holder opening and cap style before purchase so the fit stays consistent with the rest of the rod holder setup on board.