Overview

The Attwood Marine 815000 is a deck-mounted seat slide for adding fore-and-aft seat adjustment to boats that use stamped or welded seat mounts, or cast seat mounts that were not originally equipped with a slider. It mounts directly to the deck, uses front control operation, and keeps the overall installed height to 1-5/8 inches.

This is a practical upgrade when an older seating setup needs more adjustment without changing the whole base system. The aluminum construction makes sense at deck level where seat hardware sees spray, wet shoes, and regular washdowns, and the included adapters help when a post installation or swivel location needs to be changed during a retrofit.

Key features

• Deck-mounted slide for adding seat adjustment without replacing the full seating setup
• 1-5/8 inch total height keeps the installed profile low
• Aluminum construction suits exposed mounting locations around the cockpit
• Front control release is easier to reach once the seat is installed
• Works with stamped and welded seat mounts, plus cast seat mounts that were not originally equipped with a slider
• Adapters are included for changing a post installation or swivel location

Compatibility and fit

This slide is best matched to retrofit projects where the seat base itself is still serviceable, but the seating position needs more travel and easier adjustment. Before ordering, check the deck footprint available under the seat and confirm that your current mount style matches the supported stamped, welded, or cast configurations.

Because it mounts directly to the deck, it is useful where pedestal height needs to stay in check and where a seat that slides too high would change sightlines or leg position at the helm. It also helps on shared boats where different drivers or anglers need the same seat to land in a comfortable position.

Installation and use on board

The front control is handy in layouts where the rear of the seat sits close to a console, bulkhead, or livewell and there is not much room to reach behind the base. On a refit, the included adapters give more flexibility when the old post location or swivel position does not line up with the new seating plan.

This is a sensible match for owners updating a helm seat, a fishing seat, or another primary seating position where a small change in fore-and-aft position makes a real difference over a long day on the water.