Overview

The Raymarine A80327 is a 10 m transducer extension cable for Raymarine CP470 and CP570 Wide CHIRP transducer installations. It gives extra cable length when the transducer lead does not comfortably reach the sonar module, which is common on larger center consoles, sportfishing boats, cruisers, and installations where the cable needs to be routed cleanly through the hull, bilge, or equipment space.

This extension cable carries speed, depth, and temperature data, so it is suited to compatible transducer setups that use those readings. The 10 m length, equal to about 33 ft, helps avoid stretched cable runs and makes it easier to keep the connection away from sharp edges, heat sources, and high-traffic service areas.

Key features

• 10 m extension length for CP470 and CP570 Wide CHIRP transducer cable runs.
• Supports speed, depth, and temperature signal transmission when used with compatible transducers.
• Useful when the sonar module is mounted away from the transducer location, such as near the helm, in an electronics locker, or inside a protected equipment area.
• Direct extension format keeps the installation cleaner than relocating electronics or forcing a short cable path.
• Made for Raymarine CHIRP sonar installations, helping preserve the correct system connection between the transducer and sounder module.

Installation and setup

Use this cable when the original transducer cable does not provide enough reach for a clean CP470 or CP570 installation. Route the cable with proper support, keep bends gentle, and secure it so vibration, service access, and movement around the bilge or console do not strain the connectors.

For best results, plan the cable path before pulling it through the boat. Keep it clear of sharp fiberglass edges, engine heat, and high-current wiring where practical, and leave enough service loop at the sonar module for inspection or future maintenance.

Compatibility and fit

This cable is intended for Raymarine CP470 and CP570 Wide CHIRP transducer systems. It is not a universal transducer adapter, and it should be matched to the correct Raymarine transducer and sonar module setup before installation.

It is a good match for boat owners or installers who need a longer, cleaner route from the transducer location to the sonar module without changing the core Raymarine sounder setup.