Overview

The Attwood Marine 6323W7 is a 2.75 inch round LED courtesy light with a white plastic bezel, blue output, 12 VDC operation, and a 1.8 W draw. It is built for interior or exterior mounting, with fully potted electronics, a stainless steel housing, and a rated service life of 50,000+ hours.

This light fits the kind of onboard spots where you want low-level illumination without the heat and power draw of older halogen fixtures. Blue output works well around cockpit seating, helm footwells, cabin entry points, companionway steps, and other walk-through areas where night visibility matters but harsh white light is not wanted.

Key features

• 2.75 inch round courtesy light for interior or exterior mounting
• Blue LED output with a white plastic bezel for a clean finished look
• 12 VDC light with a 1.8 W draw for low current demand on house lighting circuits
• Fully potted electronics and stainless steel housing for use in exposed marine locations
• Runs cooler than comparable halogen lights and helps reduce burn risk in tight spaces
• Rated for 50,000+ hours of service life

Installation and fit

This model is a straightforward match for boats already using a 12-volt courtesy lighting circuit. The round format suits common retrofit and new-install positions in cabins, cockpits, under-gunwale areas, and deck transitions where a compact light is easier to place.

Because it is intended for interior and exterior mounting, it makes sense in areas that may see spray, washdowns, or constant vibration. Before ordering, confirm that your boat uses 12 VDC for this circuit and check the mounting location for the right face size, depth, and wire access.

Use on board

This light is a practical fit for owners replacing older halogen courtesy lights and looking for lower heat and lower power draw without giving up useful output. It also suits new builds and refits where blue courtesy lighting is being added for step lighting, accent lighting, or safer movement through the boat after dark.