Overview

The Garmin 010-12672-02 is a trim piece snap cover for a compatible echoMAP Plus 7Xcv or 7Xsv installation. It replaces the mounting trim so the display sits cleanly at the helm after a piece is lost or cracked.

This is a fit and finish part rather than an electronic accessory, so it does not affect power, sonar, charts, or networking. It simply restores the snapped-in trim around the mount area so the install looks complete.

Key features

• Fits Garmin echoMAP Plus 7Xcv and echoMAP Plus 7Xsv units
• Snap-on trim cover to replace missing or damaged mounting trim
• Helps close up the visible gap around the mount area for a cleaner look
• No wiring, setup, or software changes required
• Useful after service work, re-mounting a display, or transferring the unit between boats

Compatibility and fit

Confirm the model name on the front bezel or in the unit information screen. This trim piece snap cover is intended for echoMAP Plus 7Xcv and echoMAP Plus 7Xsv displays.

Trim parts are model-specific, and similar-looking Garmin displays often use different snap covers. If the model does not match, the cover may not seat correctly.

Installation and setup

Remove any loose or broken trim from the mount area and wipe the surface clean. Align the cover with the matching recess, then press evenly until it sits flush.

If you need to remove it later, work slowly from an edge with a plastic trim tool to reduce the chance of marking the surrounding dash or console panel.

Use on board

This is a good match for boats that get frequent washdowns, are trailered often, or have a busy helm where small trim pieces can get bumped during routine use. It also makes sense as a small spare if you rely on the same display across seasons or multiple boats.

Maintenance and care

Rinse with fresh water after salt exposure and wipe with mild soap if needed. Skip harsh solvents and abrasive pads that can scuff the surface and leave the trim looking dull.