Overview

The Garmin 010-12673-02 is a snap-in trim piece cover that finishes the mounting opening on compatible 9-inch echoMAP units, replacing trim that has been lost or cracked.

It is used on echoMAP Plus 9Xsv and echoMAP UHD 9x models, including ECHOMAP Plus 92sv, 93sv, 94sv, 95sv, 97sv and ECHOMAP UHD 92sv, 93sv, 94sv, 95sv. This is a physical mounting accessory only, so it does not change power, transducer, or network cabling.

Key features

• Snap-on trim cover for compatible 9-inch Garmin echoMAP Plus and echoMAP UHD chartplotter/fishfinder units.
• Restores an installation that looks clean and finished when original trim pieces are missing or damaged.
• Fits without wiring changes, keeping power, transducer, and network connections untouched.
• Black finish that matches common Garmin mounting hardware.

Compatibility and fit

This trim piece snap cover fits the 9-inch echoMAP Plus 9Xsv series (92sv, 93sv, 94sv, 95sv, 97sv) and echoMAP UHD 9x models (92sv, 93sv, 94sv, 95sv). Match your unit family and size before ordering, since trim pieces are not interchangeable across screen sizes.

Installation and setup

Remove any remaining broken trim and clean the mounting edge so the cover can seat fully. Align the cover with the trim area and press until it snaps into place. After your first run, check that it is fully seated, especially on boats that see a lot of vibration.

Use cases on board

This part makes sense for trailer boats, open-center consoles, and fishing rigs where the helm gets handled often and pieces can get knocked loose during service work. It also helps during refits when you want the dash to look tidy again after a display swap or rewire.

Maintenance and care

Rinse salt and grime with fresh water and wipe with a soft cloth. Avoid harsh solvents that can haze the surface.