Overview

The Garmin 010-11067-00 is a rubber flush-mount gasket for the 15-inch GPSMAP 5015 and GPSMAP 5215 chartplotters.

It sits between the display and the dash cutout to help close up the edge around the bezel, keeping spray, washdown water, and dust from working in behind the unit while leaving a cleaner finished line at the helm.

This is most useful when the display gets removed for service or re-wiring and you want the reinstall to seal and sit the same way as before.

Key features

• Made for flush-mount installs on Garmin GPSMAP 5015 and GPSMAP 5215 units
• Rubber gasket that follows the bezel to help seal the perimeter against the mounting surface
• Helps reduce gaps around the cutout so water and grime are less likely to collect behind the display
• Helps keep a flush-mounted helm install looking tidy after removal and reinstallation

Compatibility and fit

Compatibility is model-specific: this gasket matches the GPSMAP 5015 and GPSMAP 5215. It is intended for flush mounting in a dash or helm panel, not for bail or bracket mounting.

If you are sorting parts for a refit, verify the exact GPSMAP model on the back of the display so the gasket profile lines up with the bezel and cutout.

Installation and setup

Start with a clean, dry mounting surface and a smooth cutout edge. Position the gasket so it lays flat all the way around, then bring the display into the opening and tighten the flush-mount hardware evenly so the gasket compresses uniformly.

After installation, check the perimeter for pinched sections or gaps. A consistent squeeze around the bezel is what keeps the seal working through vibration, spray, and routine washdowns.

On-board use notes

This gasket is a good match for helm refits, electronics re-rigs, or replacing a gasket that has taken a set after years of heat and vibration. It also helps on open consoles where the display face is protected but the back side of the dash sees regular spray and washdown runoff.