Overview

The Garmin 010-11932-00 is a suction cup mount for select 7 inch Garmin dezl, nüvi, and RV navigators. It attaches to a windshield or to a surface that is smooth and flat, giving you a stable place to view the screen from the helm, the cabin, or a pilothouse.

This mount is commonly used with Garmin dezl 760LMT, dezl 770LMTHD, nüvi 2757LM, nüvi 2789LMT, nüvi 2797LMT, nüvi 2798LMT, and RV 760LMT units. The adjustable arm and ball joint let you set the angle for glare control and keep the display within easy reach when you need to tap the screen.

Key features

• Suction cup base mounts to a windshield or to a panel that is smooth and flat, with no drilling required
• Adjustable arm with a ball joint for tilt and rotation, so you can aim the screen from different helm positions
• Fit for select 7 inch Garmin dezl, nüvi, and RV navigators, including dezl 760LMT, nüvi 2757LM, nüvi 2797LMT, and RV 760LMT
• Powered mount cradle connection point for use with the correct Garmin power lead for your navigator
• Cradle includes a video-in jack and a speaker jack for installations that use those functions on supported devices

Compatibility and fit

This mount is made for specific Garmin portable automotive and RV models, not for fixed-mount marine chartplotters. Match your exact device model before ordering, since similar-looking Garmin units can use different cradle shapes.

Suction mounts hold best on clean glass or on clear acrylic that is smooth and flat. Textured dash surfaces, heavy curvature, and areas that see constant spray can reduce holding power.

Installation and setup

Clean and dry the mounting surface, press the suction cup firmly, then lock it in place and set your viewing angle. After the mount has been in the sun, recheck the grip before getting under way, especially if the boat lives in a hot cockpit or the windshield sees large temperature swings.

For best usability on a boat, place it where the screen is visible without blocking sight lines and where you can route any power or accessory cabling so it does not snag while you steer or move around the helm.

Electrical and system integration

If you want the navigator powered while it is mounted, connect the appropriate Garmin power lead for your device to the cradle. On boats, it helps to secure the cable so vibration does not tug on the connector and to keep any plugs away from drip paths.

When using video input or external audio, keep connections in a dry area and confirm the device supports those functions before running cables through the helm.

Use cases on board

This mount makes sense for skippers who run a portable Garmin navigator in an enclosed helm and want a quick way to move it between vehicles and the boat without adding screw holes. It also works well on boats that need a temporary screen position for dock approaches, trailering, or occasional route guidance.

Maintenance and care

Remove the mount before washdowns and store it out of direct sun when the boat is not in use, since heat can soften the suction cup over time. Wipe the suction surface clean and free of sunscreen, dust, and salt film to keep the seal consistent.