Overview

The Garmin 010-12771-00 is a suction cup mount with a powered magnetic cradle for dezl 780 LMT-S and dezlCam 785 LMT-S devices.

It attaches to a windshield or another smooth surface that is flat at the helm so the screen stays within reach and the unit charges while it is docked. The magnetic dock also makes it easy to remove the device without disturbing the mount location, which helps when you move between the boat and the tow vehicle.

This style of mount is meant for protected mounting locations such as an enclosed helm, cabin, or pilothouse. It is not a weather-sealed mounting solution for open consoles or areas that take regular spray.

Key features

• Compatible fit for Garmin dezl 780 LMT-S and dezlCam 785 LMT-S
• Powered magnetic cradle keeps the device charging while it is docked
• Suction cup base attaches to clean glass or a smooth surface that is flat without drilling holes
• Magnetic docking avoids clamp arms around the screen and supports quick removal for storage
• Easy to reposition for glare control and helm sightlines

What's included

• Suction cup mount
• Magnetic mount

Installation and setup

Start with a clean mounting surface that is dry so the suction cup can seal properly. Press the cup firmly in place, confirm it is holding, then set the viewing angle so the unit is readable from your normal helm position.

If you are using the charging feature, route the power cable so it does not snag on throttles, steering, or wiper controls, and leave enough slack to remove the device from the magnetic cradle. On boats that see vibration, check the suction hold as part of your pre-departure routine, especially after temperature swings.

Compatibility and fit

This mount is intended for dezl 780 LMT-S and dezlCam 785 LMT-S models and uses a magnetic, powered connection specific to those devices. For the most secure hold, use it on non-porous surfaces that are smooth, such as glass, acrylic, or a smooth finished panel.

Use on board

It suits boaters who run a compatible dezl unit in a protected helm as a removable navigation display or who want one mount that can move between the boat and a road vehicle during trailering and travel.

Maintenance and care

Keep the suction cup and mounting surface free of sunscreen, vinyl protectant, and salt film since residues can weaken the seal. If the mount is exposed to salt air, wipe it down with fresh water and dry it before reattaching.