Overview

The Blue Sea Systems 2710 is a snap-on cover for the DualBus 2702 busbar, sized to shield the terminal area while still leaving wire runs accessible. It is a small but useful finishing piece when you want the busbar installation to be safer and more protected inside a battery compartment, console, or distribution area.

This cover measures 6-3/8 in. long, 2-3/8 in. wide, and 7/8 in. high, with a weight of 0.04 lb. It fits the Blue Sea Systems 2702 DualBus 100A 10-circuit busbar and adds a physical barrier over the terminal area where accidental contact is most likely during service or when gear is stored close by.

Key features

• Made to fit the Blue Sea Systems DualBus 2702 busbar
• Snap-on attachment at the terminal studs for a clean, straightforward fit
• Open access around the wiring path so ring terminals and cable runs are not boxed in
• Polycarbonate construction
• Compact size at 6-3/8 in. x 2-3/8 in. x 7/8 in.
• Adds protection against accidental contact at the terminal studs

Compatibility and fit

This cover is for the 2702 DualBus 100A busbar and should be matched to that part before ordering. It is not a universal busbar cover, so the fit depends on using the correct Blue Sea Systems base unit already mounted in the boat.

For owners cleaning up a DC distribution area, this is the kind of part that helps once the busbar is already in place and wired. It suits refits and new installations where the positive and negative distribution point is mounted in a spot that may be reached during routine battery or wiring service.

Installation and setup

Installation is straightforward once the compatible busbar is in place. The cover snaps onto the terminal stud area and keeps the layout accessible, so you can still route and inspect connected wires without dealing with a fully enclosed housing.

This makes sense on boats where the busbar sits behind an electrical panel, inside a console, or near battery switching gear and chargers. It is a good match for owners who want a cleaner finish and an added layer of protection around an exposed distribution block.