Raymarine InfoLINK to RayNet Data Cable, For SR200, 2m

Overview

The Raymarine R70621 is a 2 m data interface cable for connecting an SR200 InfoLINK receiver to a RayNet network connection. It is the cable used for the SR200 data link, with RayNet on one side and InfoLINK on the other, keeping the receiver tied into the Raymarine onboard electronics network.

This cable is a fit-focused part for SR200 installations where the receiver is mounted close to the helm electronics, a network switch, or a nearby RayNet connection point. The 2 m length keeps cable runs tidy in compact helm spaces, electronics lockers, and console installations without leaving a long coil behind the dash.

Key features

• Connects a Raymarine SR200 InfoLINK receiver to a RayNet network connection.
• 2 m cable length for short, clean runs behind the helm or inside an electronics compartment.
• Supports the SR200 data connection used with Raymarine systems for SiriusXM Marine weather, Fish Mapping, and satellite radio display integration.
• Useful for new SR200 installations or replacing the SR200 data cable in an existing Raymarine network setup.
• Purpose-built cable format avoids adapting generic network leads in a marine electronics installation.

Compatibility and fit

This cable is for Raymarine SR200 InfoLINK receiver installations that require an InfoLINK to RayNet data connection. It should be matched to the SR200 receiver and the RayNet side of the vessel’s Raymarine network before installation, especially on boats with multiple displays, network switches, or tight cable paths behind the helm.

Installation and setup

Route the cable where it can be supported and protected from sharp bends, moving panels, engine heat, and standing water. In small consoles and electronics lockers, the 2 m length works well when the SR200 is mounted near the network connection point, helping reduce excess cable and keeping service access cleaner.

After connection, check that the SR200 is recognized through the Raymarine system and that the related SiriusXM functions are available on the connected displays as applicable to the receiver, display software, and active service subscription.