Raymarine Adapter Cable, CPT-60/70/80 to Dragonfly 4/5 & Wi-Fish

Overview

The Raymarine A80332 is an adapter cable for connecting compatible Raymarine CPT transducers to Dragonfly fishfinder displays and Wi-Fish systems. It is used where the transducer and display connector styles do not match, especially on setups that use the green locking collar connection.

This cable is commonly used with CPT-60 transducers on Dragonfly 4, Dragonfly 5, and Wi-Fish systems. It also supports CPT-70 and CPT-80 transducer installations where an adapter is required for a Dragonfly unit with a green locking collar.

For boat owners replacing a display, changing a transducer, or keeping an existing Dragonfly sonar setup in service, this adapter helps avoid unnecessary rewiring. It is a practical part for small fishing boats, trailer boats, and compact helm stations where Dragonfly electronics are already installed.

Key features

• Adapter cable for Raymarine CPT-60 transducers used with Dragonfly 4, Dragonfly 5, and Wi-Fish systems.
• Also used with CPT-70 and CPT-80 transducers when connecting to compatible Dragonfly units with a green locking collar.
• Helps match older or alternate transducer connections to supported Dragonfly sonar displays without replacing the full transducer run.
• Useful for service work, electronics upgrades, and refits where the sonar display and transducer remain compatible but require the correct adapter.
• Compact cable accessory that fits into the sonar connection path at the display or transducer interface, depending on the installation layout.

Compatibility and fit

Before ordering, confirm the transducer model and the connector style on the Dragonfly unit. This adapter is associated with CPT-60 connections to Dragonfly 4, Dragonfly 5, and Wi-Fish, and with CPT-70 or CPT-80 connections where the Dragonfly side uses the green locking collar.

It is not a universal sonar adapter. Matching the transducer family, display model, and collar style matters because Raymarine Dragonfly systems have used different connector arrangements across product generations.

Installation and setup

Installation is a straightforward cable connection, but the plug should be aligned carefully before tightening or locking the connector. Do not force the connection if the keyway or collar does not line up, as that usually means the adapter is not the correct match for that equipment combination.

Route the cable so it is not pulled tight behind the display and is not exposed to sharp bends, chafe points, or standing water. On small boats and open helms, leave enough service loop to remove the display later without straining the connector.

Use cases on board

This adapter is a good match for boaters maintaining a Raymarine Dragonfly sonar system while changing or reusing a compatible CPT transducer. It is especially useful during a refit where the hull transducer is staying in place and only the display-side connection needs to be matched correctly.