Raymarine Magnetic Sun Cover, For Axiom 2 XL 16

Overview

The Raymarine A80733 is a silicone magnetic sun cover made for the Raymarine Axiom2 XL 16 multifunction display. It is a size-specific cover for the 16-inch Axiom2 XL screen, helping protect the helm display face when the unit is not in use.

This cover suits boats with exposed or semi-exposed helm stations where the display may sit in direct sun between trips, during dockside storage, or while the boat is covered but the electronics remain installed. The magnetic fit keeps the cover simple to place and remove, with no straps or clips to work around at the console.

Key features

• Made for the Raymarine Axiom2 XL 16 display, so it is not a generic MFD cover.
• Magnetic attachment helps the cover sit neatly on the display face without separate retaining hardware.
• Silicone construction gives the cover enough flexibility for regular use at the helm.
• Helps shield the screen area from sun exposure, dust, fingerprints, and light cockpit debris while the display is off.
• Useful for glass-bridge and large-console installations where the display stays mounted full time.

Compatibility and fit

This cover is intended for the Raymarine Axiom2 XL 16 model only. It should be matched by display series and screen size, especially on multi-display helms where Axiom2 XL models may sit beside other Raymarine displays with different dimensions.

Because it uses a magnetic attachment, keep compass and helm-instrument placement in mind when planning or servicing the installation. The cover should be used as a protective accessory for an installed display, not as a substitute for proper helm covering during long-term storage or harsh weather exposure.

Use on board

It is a practical match for center consoles, pilothouses, sport-fishing boats, cruising boats, and other helm layouts where the Axiom2 XL 16 remains installed between runs. The cover is most useful when the display is powered down at the dock, during washdown preparation, or when the helm is not actively being used.

Care and handling

Before fitting the cover, wipe away grit or salt crystals from the display face and the inside of the cover so they do not rub against the screen surface. Rinse salt residue from the cover with fresh water as part of normal electronics care, then let it dry before storing it in a locker or console compartment.