Raymarine Axiom 2 Pro 16 Sun Cover

Overview

The Raymarine A80743 is a silicone sun cover for the Raymarine Axiom 2 Pro 16-inch multifunction display. It fits over the front of the display when the unit is not in use, helping shield the screen and helm electronics from sun exposure, salt spray, cockpit dust, and general onboard grime.

This is a simple but important protection piece for exposed helms, flybridges, center consoles, and pilothouse stations where the display may sit in direct light between trips. It has no wiring, power requirement, or network setup, so it is a fit-and-cover accessory for the Axiom 2 Pro 16 rather than an electronic upgrade.

Key features

• Made for the Raymarine Axiom 2 Pro 16-inch display, so it matches the larger screen size in the Axiom 2 Pro range.
• Silicone cover construction gives the display face a protective layer when the boat is docked, stored, or between runs.
• Helps reduce daily exposure to UV light, spray, dust, and debris at open helm locations.
• No electrical connection, 12V or 24V compatibility check, software setup, or NMEA network integration is required.
• Practical spare or replacement cover for boats with an Axiom 2 Pro 16 display already installed.

Compatibility and fit

This cover is intended for the Raymarine Axiom 2 Pro 16 display size. It should be matched to the display model and screen size before ordering, especially on boats with mixed Raymarine displays at the helm.

Use on board

A sun cover is most useful on boats where the chartplotter stays mounted at the helm full time. It is a good match for fishing boats, cruisers, sailboats, and workboats that need quick display protection after a run without removing the electronics from the station.

Maintenance and care

Rinse off salt and grit before wiping the cover, especially after washdowns or rough-weather use. Keeping the cover clean helps prevent abrasive debris from being trapped against the display face while the boat is stored.