Overview

The Simrad 000-11599-001 is a pair of edge bezels for Simrad NSS9 evo2 and B&G Zeus2 9 9 inch multifunction displays. It replaces the front trim pieces so the display edge looks clean again after UV, salt spray, or a cockpit refit that left the original bezels scratched or missing.

This is a cosmetic part with no wiring and no setup. Fit is all about matching the exact model and screen size since bezel parts are specific to the display frame.

Key features

• Fits Simrad NSS9 evo2 and B&G Zeus2 9 displays with the 9 inch frame
• Supplied as a matched pair of edge bezels
• Trim piece only with no electrical or network connections
• Restores a finished look around the display without changing your electronics system
• Useful replacement when existing bezels are cracked, scuffed, or missing after service work

What's included

• Edge bezels (pair)

Compatibility and fit

Compatible displays are the Simrad NSS9 evo2 and the B&G Zeus2 9. Other screen sizes and other display generations use different trim parts, even when the screen measurement looks similar at a glance.

If you are checking an existing install, confirm the model name on the display label or in the unit information menu before ordering.

Installation and setup

Install is typically done with the display powered down while you swap the existing trim pieces for the new bezels. For the cleanest seating, it helps to have the unit loosened enough to access the edges and press the bezels fully into place without binding.

Once fitted, verify the bezels sit flush all the way around and do not interfere with card doors, buttons, or nearby dash panels.

Maintenance and care

Rinse with fresh water after washdowns and wipe with a soft cloth. Skip strong solvents and abrasive pads, which can dull the surface over time.

This part makes the most sense for boats that live outdoors or run in saltwater where trim pieces take a steady hit from sun, spray, and hands on the helm.