Overview

The Simrad 000-11601-001 is an edge bezel set that fits the NSS16 evo2 16-inch multifunction display and comes as a pair.

It is used to finish the display perimeter at the helm so the installation looks clean after a refit, dash work, or replacement of a worn trim piece. If your NSS16 evo2 is still in service but the helm face is getting refreshed, this is the kind of small part that keeps the final result looking tidy.

Key features

• Made to fit the Simrad NSS16 evo2 16-inch display (model-specific accessory)
• Pair set for a complete edge-trim refresh
• Useful when replacing damaged trim or cleaning up the look after helm panel changes
• No electrical connections or network setup required

What's included

• Two edge bezels (pair)

Compatibility and fit

Compatibility is specific to the NSS16 evo2. Before ordering, match the exact model name on your display to avoid mix-ups with other NSS generations or different screen sizes that use different trim parts.

Installation and setup

These bezels are a physical trim accessory only. Fit them to the display frame and check that they sit flush and even all the way around before calling the job finished. Since there is no wiring involved, the main thing is confirming the correct model and getting a clean, fully seated fit.

Use on board

This set makes sense for boats that already have an NSS16 evo2 at the helm and need replacement trim after years of sun, spray, and normal cockpit traffic, or for crews doing a dash refresh where the edge finish matters.

Maintenance and care

Rinse off salt residue during routine washdowns and wipe with a soft cloth. Use mild soap if needed and avoid abrasive pads that can scuff the finish.