Overview

The B&G 000-15893-001 is a mast bracket for mounting a B&G Nemesis 9 sailing display on a spar.

This bracket is intended for a portrait-style installation and gives you a dedicated mounting point for a 9-inch Nemesis display on the mast. Overall dimensions are 255 x 163 x 210 mm (H x W x D), which helps when planning clearance around halyards, sail cover ties, and other mast hardware.

It’s a good match for sailors who want a Nemesis 9 up on the mast for quick checks while trimming, racing, or cruising, rather than relying only on a display at the helm.

Key features

• Made for B&G Nemesis 9 (9-inch) sailing displays
• Mast-mount bracket for placing the display on the spar where it can be read while sailing
• Supports portrait mounting orientation
• Overall size: 255 x 163 x 210 mm (H x W x D) for layout and clearance planning
• Useful for new installs or refits that need a dedicated mast bracket for the Nemesis 9

Compatibility and fit

This bracket is for the Nemesis 9 display size. Confirm you are mounting a 9-inch Nemesis and not a different size before ordering, and check the available space on the mast for the bracket’s depth so the display and cabling won’t interfere with sails, lines, or cover hardware.

Installation and setup

Plan the mounting height for your usual sailing position and sightline, then verify you can route the display cable cleanly along the mast without sharp bends or chafe points. Use fasteners that match your mast material and isolate dissimilar metals where needed, and seal any new holes to keep water out of the spar.

Use on board

A mast-mounted Nemesis 9 is commonly used to keep key sailing numbers visible from the cockpit or while working forward. This bracket is the hardware piece that supports that layout when the display needs to live on the mast in a portrait orientation.

Maintenance and care

Rinse salt and grime off the bracket during routine washdowns, and periodically check that the mount stays tight after heavy weather or long periods of vibration. If the mast is unstepped, it’s a good time to inspect mounting points and cable routing for wear.