Overview

The Vimar Idea 16781 Classica cover plate is a 1-module die-cast metal cover plate for panel mounting in the IDEA range. It measures 40 x 80 x 9 mm, supports horizontal or vertical mounting, and uses clamp fastening with a mounting grid.

This is the visible finishing plate for a protected switch or control position where a metal front helps the panel look more integrated with the rest of the helm or cabin interior. With an IP00 rating, it belongs in a dry interior location rather than in an exposed spot that sees spray, washdowns, or open-weather use.

It also includes a label space on the front and is listed for built-in installation, wall ducts, and subfloor duct boxes. That makes it a practical fit for enclosed switch panels, cabin service points, and other covered mounting locations on board.

Key features

• 1-module Classica cover plate for panel mounting in the Vimar IDEA range
• Die-cast metal construction with a glossy surface finish
• 40 x 80 x 9 mm overall size
• Horizontal or vertical mounting orientation
• Clamp fastening with mounting grid
• Label space on the front for circuit or function identification
• Halogen-free construction
• Listed for built-in installation, wall ducts, and subfloor duct boxes
• IP00 rating for protected interior mounting positions

Variants

This range changes by finish rather than by format. The listed variants cover white, ivory, black, metallized silver, black chrome, polished gold, brushed nickel, and chrome.

Across these options, the product stays within the same 1-module Classica panel-mounting format in die-cast metal. The choice mainly affects how the finished panel looks next to surrounding instruments, trim, and switchgear.

Compatibility and fit

This plate is made for a single module and serves as the outer finishing piece, not the switch insert itself. It suits installations where the underlying device and panel layout are already based on the Vimar IDEA system.

Because it can be mounted horizontally or vertically, it works in narrow side panels as well as standard upright switch positions. It suits refit and new-build interior panels where the controls sit under cover and the finish needs to line up with the rest of the helm or cabin hardware.

Installation and mounting

The low 9 mm depth keeps the face of the panel tidy and close to the mounting surface. On a boat, that is useful where switch panels are installed in tight helm consoles, cabin bulkheads, or service lockers and you want a clean finished front without adding unnecessary bulk.