Overview

The Simrad 000-13760-001 is a gimbal (bail) mounting bracket for Simrad NSS16 evo3, NSS16 evo3S, and Zeus3-16 16-inch displays, for mounting on a dash, console top, or overhead electronics box when you are not doing a flush install.

It comes as a metal bracket with two adjustment knobs, so you can set the viewing angle and then lock it down. That helps when sun glare, seated versus standing helm height, and boat vibration make a fixed screen harder to read.

Before drilling, dry-fit the display in the bracket and check side clearance for the knobs plus room behind the unit for connectors and a gentle cable bend. If your dash panel has some flex, add backing plates or a stiffener so the mount stays tight over time.

Key features

• Compatible gimbal mount for NSS16 evo3, NSS16 evo3S, and Zeus3-16 16-inch displays
• Two side knobs for tool-free tilt adjustment and quick re-aiming at the helm
• Metal bracket construction suited to vibration and frequent adjustment
• Works well for surface mounting where you want access to the display without cutting a flush-mount opening
• Sized for the 16-inch chassis and mounting points, so it is not interchangeable with smaller Simrad brackets

What's included

• Mounting bracket
• 2 adjustment knobs

Installation and setup

Mount the bracket on a surface that is flat and rigid, and confirm the display can tilt without hitting the dash, wheel, windshield frame, or a grab rail. Leave space behind the display for the plugs and a smooth cable bend, especially if the unit will be swung to different angles.

On boats that see spray at the helm, sealing the mounting holes helps keep water out of the console. A quick rinse after salty runs keeps salt from building up around the knobs and makes angle changes easier later on.

Compatibility and fit

This bracket matches the 16-inch form factor used on NSS16 evo3, NSS16 evo3S, and Zeus3-16 displays. If your display is a different size, the side mounting points and overall width will not align with this bracket.

Use on board

This style of mount is a good match for center consoles, pilothouses, and flybridges where the viewing angle changes with where you are standing or sitting. It also suits refits where you want the screen removable from the front for service without disturbing a panel cutout.