Overview

The Simrad 000-13743-001 is a snap-on sun cover for Simrad NSS16 evo3 and NSS16 evo3S 16 inch multifunction displays.

It keeps the display face protected while the boat is parked, trailered, or covered at the dock, helping block direct sun and keeping dust, salt residue, and everyday scuffs off the screen and bezel.

The cover seats over the front of the unit and removes quickly by hand, so it is easy to use between trips without changing your helm setup.

Key features

• Fits Simrad NSS16 evo3 and NSS16 evo3S 16 inch displays
• Hard cover that shields the screen and bezel when the unit is not in use
• Helps keep UV exposure, salt spray residue, and surface scratches off the display face
• Installs and removes by hand with no tools
• Useful for open helms where the display is exposed between runs

Compatibility and fit

This cover matches the front profile of the NSS16 evo3 and NSS16 evo3S. If your display is a different series or screen size, the fit will differ, so it is worth confirming the exact model at the helm before ordering.

Installation and use

Press the cover onto the display face until it sits evenly around the bezel. Before fitting it, wipe away any grit or dried salt so debris does not get trapped against the screen.

Remove the cover before powering up and operating the display.

Care and storage

After a salty run, rinse the cover with fresh water and let it dry before stowing. Keeping sand out of the helm area helps prevent fine scratches when the cover is installed and removed.

What's included

• Screen cover (sun cover) for NSS16 evo3/evo3S

Who it suits

A solid fit for boats stored outdoors, kept on a lift, or run hard in saltwater where the helm stays exposed. It also makes sense for anglers and cruisers who want quick protection at the dock without removing the display from the dash.