Overview

The Garmin 010-12832-10 is a replacement power cable for a Force trolling motor foot pedal, connecting the pedal to a 12V, 24V, or 36V DC power source. It uses a 2-pin threaded connector at the pedal end and bare wire leads at the power end for a hardwired connection.

This cable is typically used when the original pedal lead is damaged, or when you are rewiring the pedal to a dedicated breaker or fused distribution point near the bow.

Key features

• Powers a compatible Force foot pedal from 12V, 24V, or 36V DC systems.
• 2-pin threaded connector at the pedal end helps keep the connection from loosening with vibration.
• Bare end wires on the supply end for terminating to ring terminals, butt connectors, or a terminal block.
• Compatible with Force and Force Kraken trolling motor setups that use the matching foot pedal connection.
• Replaces the pedal power lead without changing the pedal or trolling motor.

Compatibility and fit

Use this cable with the compatible foot pedal for Garmin Force and Force Kraken trolling motors. If your foot pedal uses a different connector style, this cable will not mate correctly.

Installation and wiring

Thread the 2-pin connector onto the foot pedal power port and route the cable so it stays clear of pedal movement and deck hardware. Terminate the bare leads at your boat’s DC distribution and protect the circuit with an appropriately sized fuse or breaker, using sealed splices and strain relief where the cable transitions into the deck or console.

Use cases on board

This cable fits bow fishing setups where the foot pedal stays on the front deck and sees frequent stow and deploy cycles. It is also a practical choice during refits when the pedal is being relocated or moved onto a dedicated power circuit.