Overview

The Garmin 010-12832-00 is a high-efficiency replacement propeller for Garmin Force and Force Kraken trolling motors. It is built to run longer and keep operation quieter, which matters when you are holding on a spot, tracking a contour line, or making long moves on the bow mount.

This prop is a practical spare to keep on board for fishing trips and tournament days. It also makes sense as a direct replacement when a prop gets nicked up from sand, shell, or a hard bump at the ramp.

Key features

• Replacement trolling motor propeller for Garmin Force and Force Kraken models
• High-efficiency prop profile that runs longer and keeps operation quieter
• Replaces a damaged prop without replacing the entire trolling motor
• Useful as a spare for dockside swaps after an impact or line wrap

Compatibility and fit

This propeller is meant for Garmin Force and Force Kraken trolling motors. If your boat uses a different brand or model of trolling motor, the hub and drive interface will not match.

Installation and setup

Stow the trolling motor, disconnect power, and remove the existing prop hardware per your motor instructions. Before installing the new prop, clear any fishing line from the shaft area and check for nicks or burrs that could keep the prop from seating flat. After the prop is secured, run the motor at low speed first to confirm smooth rotation.

Use on board

This prop is a good match for anglers who spend long hours on the trolling motor and want efficient thrust with less noise from the prop. It also suits boats that see frequent shallow-water work where a spare prop can save a day on the water.

Maintenance and care

Inspect the blades regularly and remove any wrapped line after each trip. If you run brackish or salt water with a Force Kraken setup, a quick rinse after use helps keep salt residue from building up around the prop area.