Overview

The B&G 000-13725-001 is a white plastic suncover that fits over the Triton² Pilot and OP12 Pilot Controller. It keeps the front of the controller covered when the boat is sitting in the sun or taking spray at the helm, helping cut down on grime, salt residue, and screen wear between trips.

This is a simple, no-wiring accessory that goes on and off as needed, and it weighs about 0.05 lb. It is most useful on cockpits and pedestal mounts where the controller stays exposed, whether the boat lives on a mooring, at a dock, or on a trailer.

Key features

• Fitment cover for Triton² Pilot and OP12 Pilot Controller faces
• Helps shield the display and controls from sun exposure, salt spray, and airborne grit while the unit is not in use
• Rigid plastic cover that helps prevent scuffs and scratches on the front panel
• Quick to fit and remove for everyday docking, storage, and washdowns
• Lightweight cover at about 0.05 lb

Compatibility and fit

Confirm the controller model at the helm before ordering: this cover is for the Triton² Pilot controller and the OP12 Pilot Controller. Covers are model-specific, so a standard Triton² instrument display uses a different suncover.

Installation and day-to-day use

Fit the cover over the front of the controller until it seats evenly, then lift it off when you need access underway. For the best hold, wipe salt film off the bezel first so the cover can sit flush.

Care and storage

Rinse the cover with fresh water after heavy spray or washdowns and let it dry before storing it in a locker. Avoid abrasive cleaners that can scratch the surface and transfer marks onto the display.

On-board use notes

This cover suits boats that keep the pilot controller mounted in the cockpit, on a pedestal, or in an exposed nav pod where sunlight and salt mist are part of normal use. It also makes sense for charter and racing crews who want the controller protected while the boat is tied up between sessions.