Raymarine Cyclone Radar Power Cable

Overview

The Raymarine Cyclone Power Cable is a dedicated power cable range for Raymarine Cyclone radar installations, giving installers a proper cable length for the run between the radar scanner and the vessel power connection. It is offered in 5 m, 10 m, 15 m, and 25 m lengths, which helps keep routing clean on different boat sizes without relying on unnecessary excess cable.

This cable is used when fitting a Cyclone radar on a hardtop, radar arch, mast, tower, or other elevated mounting point where the power run has to pass through confined areas and exposed marine spaces. Selecting the right length matters because radar cabling is often routed through liners, conduits, deck glands, and service loops before it reaches the electronics or distribution area.

Key features

• Dedicated power cable range for Raymarine Cyclone radar installations.
• Available lengths cover short helm-top runs as well as longer routes through arches, masts, towers, and cabins.
• Length options include 5 m, 10 m, 15 m, and 25 m, with equivalent lengths of 16.4 ft, 32.8 ft, 49.2 ft, and 82.0 ft.
• Useful for new radar installations and for replacement cable runs where the existing route or mounting point changes.
• Supports cleaner cable planning by matching the cable length to the vessel layout instead of leaving large coils in service areas.

Variants

This product is offered in multiple length configurations for different Cyclone radar cable routes.

The main difference between the variants is cable length. The application remains the same across the listed options: supplying power for a Raymarine Cyclone radar installation.

• A80651: Length 5M. This shorter cable suits compact installations where the radar is close to the power connection or electronics area.
• A80652: Length 10M. This length gives more routing space for hardtop, arch, or small cabin runs where a short cable would be too tight.
• A80653: Length 15M. This option is practical for larger boats or more indirect routes where the cable passes through several compartments.
• A80654: Length 25M. This long cable is useful when the radar is mounted far from the power connection, such as on a mast, tower, or extended cable path.

Installation and routing

Plan the cable path before pulling the cable through the boat. Radar power cables are commonly routed through deck glands, radar arches, overhead liners, conduits, and equipment spaces, so allowing for bends, service loops, and access points can prevent strain at the scanner and at the connection end.

Keep the run protected from sharp edges, moving gear, hot engine-room surfaces, and areas where water can collect. On exposed deck or mast routes, the cable should be supported and sealed according to the vessel installation method so vibration and washdowns do not compromise the connection over time.

Compatibility and fit

This cable range is for Raymarine Cyclone radar systems. It is a power cable, not a radar data cable and not a transducer extension cable, so it should be matched to the Cyclone radar power connection required for the installation.

It is a good match for owners, installers, and refit yards working on Cyclone radar installations where the cable length needs to suit the actual route through the vessel rather than only the straight-line distance to the scanner.