Overview

The Vimar VM20660.13 is a 14 (7+7)-module Classic cover plate in silver technopolymer for Vimar Eikon modular wiring devices. It finishes a wide bank of switches, outlets, or control modules with one clean plate, so helm, cabin, and service-area controls stay aligned and easy to read at a glance.

For onboard installs, plan on using it in interior or protected locations where hands are wet or salty and surfaces get wiped down often. Technopolymer does not corrode, which helps in coastal and offshore environments, but the installation should still be kept out of direct spray or washdown unless the rest of the system is protected accordingly.

Key features

• 14-module layout (7+7) for grouping multiple Eikon modules on a single plate
• Technopolymer construction with a silver finish
• Made for the Vimar Eikon modular format where fit is based on module count
• Covers frame edges and device openings for a clean, finished panel look
• Non-metallic face plate that will not pit or oxidize from salty air

Compatibility and fit

This cover plate matches a 14-module Eikon arrangement with two rows of 7 modules. Confirm your layout by counting the modules in the frame behind the plate or by checking the cutout and frame size before ordering, especially when replacing an older plate where series and module spacing may differ.

Installation and setup

Install the plate after the Eikon mounting frame and the modules are secured and sitting square. A quick dry-fit before final tightening helps keep the rows straight, which matters on a long 7+7 plate where small misalignment is easy to see.

Once installed, check that the plate sits flush against the bulkhead or panel and that all buttons, rockers, or modules move freely without rubbing the edges.

Use cases on board

This plate is a good match for boats that use Vimar Eikon switching and want a single, wide control point for circuits such as lighting zones, pumps, accessories, or cabin services. It also works well at companionway entries, nav stations, and utility panels where you want multiple functions in one tidy location.

Maintenance and care

Wipe with fresh water after salt exposure and clean with mild soap and a soft cloth. Avoid aggressive solvents or abrasive pads that can haze the surface.