Overview

The Garmin 010-12832-19 is a white replacement skeg for the Force Kraken trolling motor. It sits below the drive and takes the first hit when you brush a rock, stump, or bottom, helping protect the motor housing and propeller from impact damage.

This is a straightforward replacement when the original skeg is cracked, worn down, or missing. The white color keeps the lower unit looking consistent on white Force Kraken setups.

Key features

• Made to fit the Force Kraken trolling motor.
• Standard skeg profile that helps shield the motor and propeller area from impacts and abrasions.
• Useful protection when running shallow water, working shorelines, or launching at rough ramps.
• White finish to match white Force Kraken motors.
• Good spare to keep onboard for long trips or tournament days where a damaged skeg can end a session early.

Compatibility and fit

Confirm you have a Garmin Force Kraken trolling motor before ordering. Skegs are model-specific, and fit depends on the lower unit shape used on the Kraken series.

Installation and setup

Power the trolling motor off and secure it in the stowed position before working on the lower unit. After installing the skeg, re-check that it sits straight and is firmly secured before you head back on the water.

Use cases on board

This skeg makes the most sense for boats that spend time around structure and skinny water, including bass rigs, bay boats, and inshore skiffs that regularly bump bottom while positioning quietly. It also helps for trailered boats that see frequent launches where the lower unit can get knocked around at the ramp.

Maintenance and care

Rinse after use and give the skeg a quick look when you clean the trolling motor. If you take a hard hit, inspect it before the next run and replace it if it is cracked or badly worn.