Overview

The Garmin 010-12525-00 is a powered quick-release mount for compatible inReach handheld satellite communicators, so you can keep the device secured in a fixed spot while it stays charged over a USB connection.

It uses the AMPS mounting pattern, which makes it straightforward to pair with many common marine mounting bases and brackets at the helm, nav station, or inside the cabin. The built-in release tab lets you remove the inReach in one hand when you need to take it on deck or into the dinghy.

Because this mount charges through exposed contacts, placement matters on a boat. Mount it where spray and washdowns are limited, and keep the contacts dry to avoid damage.

Key features

• Fits inReach SE+ and inReach Explorer+ handheld satellite communicators.
• Quick-release cradle for easy removal and re-docking with one hand.
• AMPS mounting pattern for compatibility with many standard mounting bases and plates.
• Integrated USB power cable to keep the inReach charged while underway.
• Weather cap for protecting the mount contacts when the device is removed.
• Contact-care guidance built into the mounting routine: keep the metal contacts dry before docking the device.

Compatibility and fit

This mount is intended for inReach SE+ and inReach Explorer+ units that charge through the rear contacts. If you are using a different inReach model, confirm the physical fit and charging contact layout before committing to a permanent install.

Installation and setup

Choose a mounting location with a clear view for normal device use and with practical cable routing back to power. On most boats, power is handled by plugging the USB lead into a helm USB outlet or a 12V or 24V to USB adapter that is protected and wired cleanly behind the dash.

If you are attaching the mount to an AMPS base plate, tighten the fasteners evenly. A typical torque target for the base plate hardware is 1.7 to 2.25 N-m (15 to 20 lbf-in). Mounting plates and hardware can vary by installation, so match screw length and backing support to your surface.

Use cases on board

This setup makes sense for coastal cruising and offshore runs where the inReach lives at the helm for tracking and messaging but still needs to come off the bracket quickly. It is also a good fit for skippers who want the device charged and in one consistent place during day trips, fishing runs, and night passages.

Maintenance and care

Rinse salt from the surrounding area with care and avoid directing water at the contact area. When the inReach is off the mount, cover the contacts with the weather cap and let everything dry before docking the device again.