Overview

The Attwood Marine 11260-1 is a pair of 8 inch offset panel brackets for trailer roller mounting and adjustment. This is trailer hardware rather than onboard hatch hardware, and it is used where a roller needs offset placement and some adjustment during setup.

The brackets are zinc-plated steel and use a slotted design to help line up the roller assembly with the hull as the boat loads, centers, and supports on the trailer. The 8 inch length and 5/8 inch hole size are the key fit points to check against your current trailer hardware before ordering.

This part makes sense for trailer repairs, roller replacement, or correcting roller position on bunk and roller trailers where the existing bracket is bent, worn, or no longer lines up cleanly with the boat.

Key features

• Pair of 8 inch offset panel brackets for trailer roller mounting
• Slotted bracket shape allows position adjustment during trailer setup
• Zinc-plated steel construction for common marine trailer hardware use
• 5/8 inch hole size to match the related roller mounting hardware
• Useful when replacing worn brackets or correcting roller alignment on the trailer

Installation and fit

Check the bracket length, hole size, and the offset needed at your roller location before installation. These brackets are used as part of the trailer roller assembly, so fit depends on the existing roller, shaft hardware, and the mounting panel or support where the bracket bolts in place.

For trailers that see frequent launch ramp use, rinse the hardware after saltwater exposure and inspect the roller assembly during routine trailer service. That matters most where vibration, road spray, and repeated loading can loosen or wear trailer components over time.

What’s included

• Two offset panel brackets