Overview

The Vimar EIKON Series is a family of 3-module metal cover plates for Vintage controls, with a 122 x 90 mm face size, a depth of 7.15 mm, and support for either horizontal or vertical mounting. Across this range, the plate keeps the same footprint while the visible layout changes between 1 hole, 2 holes, and 3 holes, so the trim can match the control arrangement already planned at the panel.

These cover plates are suited to protected interior locations on board where a clean finish matters as much as fit, such as cabin switch panels, saloon bulkheads, and sheltered helm areas. The lacquered metal construction, clamp mounting, and support for built-in installation, wall duct use, and subfloor duct box use make them a practical finishing piece for a marine electrical installation built around the Vimar format.

Because this range is rated IP00, it is better suited to dry, protected mounting locations rather than exposed deck or washdown areas. A label space is built into the plate, which helps keep circuits and functions easier to identify after installation.

Key features

• 3-module cover plate range available with 1-hole, 2-hole, or 3-hole layouts
• 122 x 90 mm overall size with a slim 7.15 mm depth
• Can be mounted horizontally or vertically to suit the panel layout
• Clamp mounting with support for built-in installation, wall ducts, and subfloor duct boxes
• Lacquered metal face with an integrated label space
• IP00 rating for protected interior mounting locations

Variants

This range varies by finish and by opening layout. Finish options include Anthracite Grey, Brushed Nickel, Dark Bronze, Matt White, Satin Gold, and Vintage Gold, and each finish is offered with 1 hole, 2 holes, or 3 holes.

The shared format across the range is the same 3-module EIKON cover plate footprint and mounting style. The main fit decision is matching the visible opening count to the number of controls at the faceplate, then selecting the finish that best matches the rest of the cabin hardware and switch trim.

Installation and fit

Check the opening layout before ordering so the plate matches the number of visible controls at the switch position. The fixed outer dimensions help keep the look consistent across the boat, while the choice of 1, 2, or 3 holes lets each station be finished to match its actual control layout.

For marine use, this product is a good match for interior refits and new builds where the switch system is installed in a protected location and the finish needs to stay consistent across cabins, companionways, and enclosed control panels. It is less appropriate for places where the plate would be exposed directly to spray, standing water, or frequent washdowns.