Overview

The Vimar Eikon 20041 Blank Module is a 1-module blank insert for closing an unused opening in a flush-mounted Eikon switch or outlet assembly. It has a 22.30 x 49.00 x 20.50 mm body, built-in mounting, and claw fastening, so it sits in the same modular layout as the active devices around it rather than leaving an open space in the panel.

This is a non-electrical component with nominal voltage listed at 0 V, so its job is purely to finish the layout and keep the face of the panel clean and consistent. The body is thermoplastic, halogen-free, and finished in matte white, grey, or silver depending on the variant. On board, it makes sense anywhere a helm panel, cabin switch bank, or interior control point has an unused 1-module position that still needs a finished look.

Key features

• 1-module blank insert for unused openings in Vimar Eikon modular assemblies
• Body size of 22.30 x 49.00 x 20.50 mm for standard 1-module fit within the range
• Built-in mounting with claw fastening for flush-mounted installations
• Thermoplastic construction that is halogen-free
• Matte front surface with label space on the module face
• Non-electrical insert with nominal voltage 0 V and no monitoring contact

Variants

This product is offered in multiple colour configurations within the same 1-module blank insert format.

Across the range, the size, 1-module layout, built-in mounting, claw fastening, thermoplastic body, halogen-free construction, matte appearance, and front label surface stay consistent. The main difference is the visible finish, with white, grey, and silver options for matching nearby plates and devices.

• VM20041.B: White. This version keeps the panel light in appearance and suits layouts built around white Eikon plates and devices.
• VM20041: Grey. This version matches grey Eikon layouts and keeps unused module positions visually consistent with darker switch panels.
• VM20041.N: Silver. This version uses the silver Next finish for installations built around silver-toned Eikon trim and devices.

Compatibility and fit

This blank module is a good match for installations that already use the Vimar Eikon modular system and need to close a spare 1-module opening without changing the frame layout. It is most useful during refits, when a device has been removed, or when extra module space is being left available for later expansion.

Before ordering, check the series, module count, and panel finish already on the boat. The blank module matches the Eikon family and fits a single module position, so it should be paired with the correct Eikon support and cover plate arrangement already in the panel.

Installation and setup

Because this is a built-in insert with claw fastening, it is suited to flush panel work where you want the face of the assembly to stay neat and even. There is no circuit function to wire, which makes it a straightforward way to finish a panel opening while keeping access to the same modular layout for future changes.

It is a sensible option for boat owners, installers, and yards tidying up helm stations, cabin switch banks, or interior panels after equipment changes. It also works when a new panel is being built in stages and one module position needs to stay closed until another device is added later.