Overview

The JL Audio Mount Fixture for VeX Enclosed System is a swivel mount fixture set for installing VeX enclosed speaker pods on a boat, either on round tubing or on a flat mounting surface. Pipe-mount versions are sized to match common tower and rail diameters from 0.75 in up to 3.25 in, and the range also includes surface-mount versions for hardtops, bulkheads, and other solid panels.

This hardware is used most often on wake and surf boat towers, T-tops, radar arches, and grab-rail style tubing where the speakers need to stay locked in place through vibration and repeated spray. Once mounted, the swivel style lets you aim the pods where you want them and then clamp them down.

These fixture sets are sold as a pair for mounting two pods, which keeps the port and starboard install consistent and helps with alignment when you are setting speaker angles.

Key features

• Mount fixture set for JL Audio VeX enclosed speaker pods, with configurations for pipe mounting or surface mounting
• Pipe-mount sizing covers round tubing from 0.75 in to 3.25 in, so you can match common tower and T-top tube diameters
• Surface-mount configurations for flat mounting locations, offered in black or clear finishes
• Swivel-style mounting that allows aiming the pods before locking the position down
• Sold as a pair to mount two pods with the same hardware and orientation
• Pipe-mount versions use strap-style clamps and include a protective strip to help reduce marring on painted or coated tubing

Variants

This mount fixture is offered in multiple configurations that differ by mounting style, pipe size, and finish. The pipe-mount configurations are listed by the tubing size in inches, and the surface-mount configurations are listed without a tube size.

Across the range, the differences come down to how the fixture attaches to the boat and what it fits: pipe-mount versions match specific round tube diameters, while surface-mount versions fasten to a flat panel and are available in black or clear.

Compatibility and fit

These fixtures are meant for VeX enclosed speaker pods and the matching VeX mounting interface. If you are mounting a different speaker family or a soundbar, confirm the mounting pattern and clamp style before ordering.

For pipe mounting, measure the outside diameter of the tube where you plan to mount and match that measurement to the listed pipe size. On towers and hardtops, also check clearance for the pod body and for the swivel travel so the speakers can be aimed without hitting canvas, handholds, or overhead electronics.

Installation and setup

On pipe installs, place the protective strip between the clamp and the tube, then tighten the hardware evenly so the clamp seats square. On surface installs, mount to a solid area of fiberglass, aluminum, or composite that can take the load of the pods under chop, and seal any penetrations to keep water out of the core.

After your first run, recheck fasteners once everything has settled, especially on boats that see heavy tower vibration or frequent trailering.

Use cases on board

This is a good match for boaters running VeX pods on a wake tower or hardtop who need a clean, repeatable way to mount and aim the speakers. It also suits center consoles with a T-top where the pods need to sit tight against a round frame tube without slipping when the boat is pounding.

Maintenance and care

Rinse the mounts after saltwater use and periodically check clamp tightness. If the boat is stored outdoors, a quick wipe-down helps keep the finish looking clean and prevents salt buildup around fasteners and clamp edges.