Overview

The JL Audio ETX-CVR speaker covers are neoprene covers that protect ETX enclosed tower speaker systems during storage and trailering. They come in two sizes for 7.7-inch and 8.8-inch enclosures, and each cover uses 3 mm neoprene laminated with dark gray spandex with a front #5 zipper with a locking slider.

The material is UV-resistant and has been tested for over 1,000 hours of salt/fog and UV exposure. Small laser-cut holes at the bottom let water drain out while keeping insects out, which matters when the boat sits at the dock or on the trailer.

This is a good match for wake and surf boats, center consoles, and cruisers that run tower speakers and spend time in open air between outings, especially if you trailer often or keep the boat uncovered.

Key features

• Two size options to match 7.7-inch or 8.8-inch ETX enclosed tower speaker systems
• 3 mm neoprene construction with dark gray spandex lamination
• UV-resistant material with over 1,000 hours of salt/fog and UV testing
• Front #5 zipper with locking slider for quick on and off
• Laser-cut drain holes at the bottom to shed water while keeping insects out
• Cut and stretch allow use with different mounting clamps and applications

Variants

This cover set is offered in multiple configurations to match different ETX enclosed tower speaker sizes.

The main difference between the variants is the enclosure size the covers fit. Construction details like the 3 mm neoprene build, front zipper closure, and bottom drain holes remain consistent across the range.

• 010-13834-00: Size 7.7 in. Sized for 7.7-inch ETX enclosed tower speaker systems so the cover sits snug without fighting the zipper.
• 010-13835-00: Size 8.8 in. Sized for 8.8-inch ETX enclosed tower speaker systems, giving full coverage over the enclosure while it stays mounted on the tower.

What’s included

• Two protective speaker covers (sold as a pair)

Compatibility and fit

These covers are made for ETX enclosed tower speaker systems (v2 or v3). The shape works with a range of mounting clamp styles, so you can typically cover the speakers without removing tower hardware.

Match the cover size to your speaker enclosure size. If you are unsure whether your speakers are the 7.7-inch or 8.8-inch version, confirm the enclosure size before ordering.

Installation and setup

Slip each cover over the speaker enclosure, orient the drain holes at the lowest point, then close the front zipper. Take a second to check that the zipper is not pinching a cable or tower hardware so the cover lays flat.

Maintenance and care

Rinse with clean, fresh water and let the covers air dry. Avoid harsh chemicals or aggressive cleaners that can shorten the life of neoprene and the zipper hardware.