Overview

The Garmin 010-12167-00 is a replacement SD card door that covers the memory-card bay on select Garmin marine displays. It restores the protective door that keeps the card seated and the slot covered when the helm is exposed to spray, salt residue, and routine washdowns.

This door is used on GPSMAP 7408, 7410, 7412, 7416 (including xsv versions), GPSMAP 7608, 7610, 7612, 7616 (including xsv versions), and GPSMAP 1222 and 1242 Plus or Touch models (including xsv versions). It is also listed for the Volvo Penta Glass Cockpit System.

It is a small service part, but it matters if you swap chart or sonar cards, keep a card installed full time, or simply want the card area closed and protected again after the original door cracks or goes missing.

Key features

• Replacement SD card door for the physical memory-card access opening on compatible marine displays
• Helps keep the memory card seated and the slot covered from grime and splash at the helm
• Compatible with GPSMAP 7408, 7410, 7412, 7416 (including xsv versions)
• Compatible with GPSMAP 7608, 7610, 7612, 7616 (including xsv versions)
• Compatible with GPSMAP 1222 and 1242 Plus or Touch models (including xsv versions) and the Volvo Penta Glass Cockpit System
• No wiring or software setup involved; this part replaces the door only

Compatibility and fit

Because Garmin uses different door shapes across families and generations, match your unit by model and by the style of the existing card door. If your display is from a different GPSMAP series than those listed above, this door may not seat or latch correctly even if it looks similar at a glance.

This part is for the card door itself. Charts, memory cards, and other hardware are not part of the door replacement.

Installation and setup

Install it the same way as the original door: remove the damaged or missing door, fit the replacement in place, then check that it closes fully and stays closed under light vibration. After installation, confirm the card inserts and ejects normally and that the door does not bind when opened and closed.

Use on board

This is a practical fix for boats that run with a flush-mounted helm display, see frequent card changes for chart regions, or keep a chart card installed year-round. It is also a good match for owners who want the card bay covered again before the boat goes back into saltwater service.

Maintenance and care

Rinse salt residue off the helm area with fresh water and wipe dry so grit does not build up around the door. Avoid harsh solvents on the door and surrounding bezel to prevent surface damage over time.