Overview

The Garmin 010-13307-30 is a pull rope and cleat kit used to replace worn pull-rope hardware on compatible Force Current kayak trolling motors. It’s meant for the motor’s rope system, so you can swap out parts that have started to fray, slip, or crack after lots of launches, beaching, and rinse downs.

This is a model-specific service kit, not a general-purpose deck cleat pack. If you are running a different trolling motor family, the rope routing and cleat style may not match.

Key features

• Replacement kit for the pull-rope components used on compatible Force Current kayak trolling motors
• Refreshes the rope tie-off hardware without changing any electrical or control parts on the motor
• Helpful when the existing rope shows fraying, the handle is damaged, or the cleats no longer hold the rope cleanly
• Built around the Force Current pull-rope layout, so fit and function stay consistent with the original setup

What’s included

• Pull handle
• Pull rope
• Cleats

Compatibility and fit

Fit is intended for compatible Garmin Force Current kayak trolling motors. Before ordering, confirm your trolling motor is a Force Current model and that you are replacing the pull-rope and cleat hardware (not power cables, mounts, or control parts).

Installation and setup

Replace the worn components in the same locations as the originals, and confirm the rope runs freely through its path before heading out. After installation, test the rope hold on the cleats at the dock so you know it grips the way you expect when your hands are wet or you are wearing gloves.

Maintenance and care

Rinse after saltwater use and keep an eye on the rope for abrasion where it contacts guides or edges. If you routinely launch through sand or mud, a quick rinse and visual check after each trip helps the rope and cleats stay predictable.