Overview

The Garmin 010-12676-15 is a 0-degree pole mount for the Panoptix LiveScope LVS32 transducer, keeping the transducer level on the pole for a straight, consistent view.

It is commonly used in ice fishing where you want the LVS32 sitting square under the hole, and it also works for open-water scanning from a pole when you want to aim LiveScope by rotating the pole instead of repositioning the boat.

Key features

• Made to mount a Panoptix LiveScope LVS32 transducer on a pole setup.
• 0-degree mounting angle keeps the transducer level relative to the pole for a clean forward/down presentation.
• Useful when watching a jig or lure under the ice where small angle changes are noticeable on screen.
• Works for open-water use on a pole when you want to sweep the beam around structure by turning the pole.

Compatibility and fit

This mount is intended for the Panoptix LiveScope LVS32 transducer. LiveScope transducers and brackets are not all interchangeable, so confirm your transducer model before ordering.

Installation and setup

Mount the LVS32 to the bracket and align it so the transducer face stays level when the pole is vertical. On an ice pole, this helps keep your sonar view stable while you fish the hole.

Route the transducer cable up the pole with gentle bends, leave enough slack for rotation, and secure it so it cannot snag on cleats, rails, or the ice edge. Recheck mounting hardware after the first outing and anytime the setup takes hard knocks in a sled, truck, or rough chop.

Use on board

This is a good match for anglers running an LVS32 on an ice kit, and for boats that want a quick pole-deploy option to scan docks, brush, and channel edges without committing to a permanent transducer mount location.

Maintenance and care

If you use the pole mount in saltwater, rinse the mount and transducer with fresh water after the trip and let everything dry before storage. Periodically inspect for loosened fasteners from vibration and transport.